Ever Poweline RT Rack 3000VA Manuel d'instructions télécharger pdf (Page 31)

Instruction manual for Powerline RT

2011/04/19

www.ever.eu

The UPS comes with factory-installed jumper connecting outputs 1 and 2. These

outputs must be joined in order for the device to operate properly.

In order to use the remote power off (EPO), remove the jumper and join outputs 1

and 2 using a standard volt-free closed contact. If the contact is open, the UPS will

switch off. In order to resume regular work, close the contact and restart the device,

following the procedure described previously.

In order to use the remote on function (RPO), join outputs 1 and 2 with the jumper

(UPS comes with factory-made jumper) and then joint outputs 2 and 3 using a

standard volt-free closed contact. Opening of the contact will switch the UPS off.

Closing of the contact will restart the UPS and supply power to the connected

receivers.

BATTERY MAINTENANCE

CLEANING

Scrubbing powders or solvents must not be used to clean the UPS.

Do not let any liquid ingress into the UPS.

Make sure that the ventilation openings on the UPS are not covered. Remove dust

from the ventilation openings using a vacuum cleaner.

The UPS casing should be cleaned from outside by wiping it with a dry or moist cloth.

UPS STORAGE

If the UPS is stored over a longer period in the ambient temperature in excess of

25ºC, the batteries should be charged for five hours, every four months. If the

ambient temperature in the storage location is higher, it is recommended that storage

time is shortened to two months.

You do not need to unpack the device to charge the batteries. The UPS should be

simply connected with a cord to the power grid, using special openings in the

packaging, and the batteries should be charged for about five hours. After charging,

the charging date should be entered on the UPS packaging.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37

Pas de commentaire

Ever Poweline RT Rack 3000VA Manuel d'instructions Page 31